![]() Showcase Your Armor Knight Competition (2019.09).iClone Lip Sync Animation Contest (2021.07).In that case, one must adjust the emit volume as everyone else suggested, so that the particles originate from a volume the size of the cigarette end but one must also adjust the size of the actual particles as I suggested, so that you don't have a cigarette spewing huge plumes of smoke. I think our disagreement comes from the ambiguity in the original post complaint that "the smoke is bigger than the character's head." IClone's pre-fab smoke particles are sized so that they appear to come from a campfire, for example. I'm not saying you are totally wrong, but using only the Particle Keys is very limiting to the power that the particles can produce.Ĭricky () Going to have to disagree with you on this: Those keys give you initial setup for size, color and opacity per single emitter. The ones you refer to are to get initial size, color(s) and opacity should you want it to fade or taper.įour examples of the Basic1 emitter are shown with the arrows pointing to the inset that each one produces based on Emit volume not the Particle Key for which they all have the same setting used for the Particle Key.Īll the settings below Emit Volume can change the Particle emitted including Wind and Gravity can be used also to make the Particle Emitter react a whole lot differently that it's initial size color and opacity, but that's a different set of rules. See the image: The Emitter Volumes control density and scale. Going to have to disagree with you on this: Those keys give you initial setup for size, color and opacity per single emitter. You may need to adjust the quota and emit rate too, to make it look just right. Click on each tab and you will be able to adjust the color, opacity, and size of the particle at that point in its lifetime.įor cigarette smoke, use one of the pre-fab smoke particles, but scale everything down by a factor of 10 to start, then scale up or down as needed. The two middle ones can be moved around as necessary. There are four little tabs along a line that represents the particle's lifetime. Scroll down the particle's Modify panel until you see the "Particle Key" section. You need to adjust the size of the particles themselves, not the emit volume. SKYPE ID: rc.650 ]Reallusion Store Content " If I had Alzheimer's (Old Timers), would I know it? "Įmerald Animation (formerly reelcheapfilms) () The quality back then was not as good as can be achieved now, so it would look better if done today. ![]() One for the cigarette, and one for the exhale. This is a smoke particle I made for an iClone user (Kenny) almost 5 years ago. The use of a Particle gives you more control, and even though it may seem to be hard to line up, you can attach it to a dummy for positioning then link or attach it to the position you want. are really (really) hard to create a decent loop that can be extended. The only problem with using a video is eventually it will reveal a broken loop. I put a blue glow on it (just a touch) and with HDR tuned just-so, the effect is really cool! I'll post the results later. ![]() I had to apply the video to the Diffuse, Opacity, and Blend channels, which gives 3 instances of the video in the timeline and they all have to be lined up in order to work, which takes some doing when you want to adjust timing. It's a little bit of a headache in iClone, (right click-drag the video file into iClone, and select "Plane"). ![]() mp4 source to RGBA (prematted, alpha) avi for iclone, using After Effects. In the meantime I've come up with a really good smoke composite using a video source texture on a plane.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |